Motorola Solutions Nexus NS750 Remote Speaker Microphone.

Introducing the Nexus NS750 Remote Speaker Microphone from Motorola Solutions, compatible with
the MOTOTRBO R7 DMR two way radio & Motorola Solutions MXP600 TETRA hand portable.

The ability to get your message across is critical, no matter where you are. The Motorola Nexus NS750 Remote Speaker Microphone allows you to communicate clearly in difficult conditions such as a fireground. With IP68 approval, this RSM can withstand immersion up to one metre for at least 30 minutes and is completely dust-tight.

The Nexus NS750 RSM features IMPRES technology, which reduces ambient noise, improves voice intelligibility, and amplifies quiet transmissions, while the Active Noise Cancellation (ANC) lets you communicate clearly in the harshest of environments.

Motorola Solutions has designed this remote speaker mic with a full suite of controls, including volume controls to change how loud transmissions are received, an emergency button for signalling distress and requesting assistance, and a programmable button for putting your favourite features at your fingertips.

Additionally, the Nexus-jack supports an open ATEX/IECEx interface, allowing the use of third-party headsets that have compatible interfaces, such as the Draeger FPS-Com-Plus.

Experience ultimate usability and extreme performance
with the Nexus NS750.

Motorola Nexus NS750 RSM

Nexus NS750 key features.

ns750 audio icon

IMPRES AUDIO
Advanced Active Noise Cancelling

ns750 smart audio switching icon

SMART AUDIO SWITCHING
Switch easily between RSM and secondary accessory, vice versa

ns750 extreme performance icon

EXTREME PERFORMANCE
Rugged, robust, reliable, IP68

ns750 flexible wearing icon

FLEXIBLE WEARING
Attachment clip

ns750 large ptt button icon

LARGE DUAL PUSH TO TALK BUTTON
Textured PTT button

ns750 colour id icon

COLOUR IDENTIFICATION
Yellow, Green, Blue, Orange, Red, Silver

NS750 accessories.

NEXUS interface (Rx Tx).

GMMN4585A

GMMN4585A
SAVOX HC-1 Helmet-com Unit Bone Conduction Mic/Single Speaker

GMMN4584A

GMMN4584A
SAVOX HC-2 Helmet-com Unit Bone Conduction Mic/Dual Speaker

PMLN8265A

PMLN8265A
3M™ Peltor Headband Headset w/Nexus Connector

PMLN8266A

PMLN8266A
3M™ Neckband Headset w/Nexus

PMLN8267A

PMLN8267A
3M™ Peltor Hard Hat Headset Attachment w/Nexus Connector

PMLN7188B

PMLN7188B
3.5mm Audio Jack Earpiece with Clear Comfort Tube

MSA Gallet F1XF

MSA Gallet F1XF

MSA C1 Communication Module

MSA C1 Communication Module

Draeger FPS-COM 7000

Draeger FPS-COM 7000

Draeger FPS-COM 5000

Draeger FPS-COM 5000

Remote Speaker Microphone MINI GCAI Audio Connector (Compatible with MOTOTRBO R7 & MXP600)

Nexus NS750

PMMN4150A
Impres Omni with large front PTT, Nexus, 3.5mm (long cable)

Nexus NS750

PMMN4151A
Impres Omni with large front PTT, Nexus, 3.5mm (short cable)

Identification Rings

PMLN8468A yellow id ring

PMLN8468A
Yellow PTT Label (10 Per Pack)

PMLN8464A green id ring

PMLN8464A
Green PTT Label (10 Per Pack)

PMLN8465A blue id ring

PMLN8465A
Blue PTT Label (10 Per Pack)

PMLN8466A red id ring

PMLN8466A
Red PTT Label (10 Per Pack)

PMLN8523A orange id ring

PMLN8523A
Orange PTT Label (10 Per Pack)

PMLN8469A silver id ring

PMLN8469A
Reflective Silver PTT Label (10 Per Pack)

FAQs

Q. Which radios are compatible with the NS750?
A. MOTOTRBO R7 and MXP600 are compatible with the NS750. For the NS750 to be detected and using the optimised audio parameters, the device will need to be upgraded to a minimum of the following software versions;
TETRA: MR2022.04, MOTOTRBO: M2022.03.

Q. Is the NX750 ATEX approved?
A. No, at this stage the NS750 is not an ATEX approved version. It is compatible with non ATEX and Intrinsically safe TIA environments only.

Q. How long is the cable?
A. Long cable is ~49.1 cm, short cable is ~25.7cm. Measured from the NS750 start of cable to the radio device interface.

Q. How many identification labels are included per pack?
A. There are 10 identification ring labels of the same colour per pack.

Q. What is the material the identification labels are made from and how rugged are the identification labels?
A. The material of the identification labels are made from polycarbonate-sheet [pc sheet]. It is the same material used in the Omni RSM Back Label which has been tested and proven on a fire scene.

Q. What is the warranty period?
A. A one year warranty is included as standard. Please liaise with Radiocoms for further information here

Motorola Platinum Reseller

Let’s start a conversation

If you would like further information, or to discuss your requirements onsite:
Book An Appointment | Arrange A Quotation | Call 033 3939 0022

radiocoms grey
Connect with us